Quicktime video. [4.0MB] Windows Media video [1.3MB]

Upon opening container pour off protective layer of water. Remove amount of material needed. Dab dry excess moisture with cloth or rag. Important: When not in use keep putty level in can and top again with ordinary tap water. Place lid on tightly to keep material from drying inside container. On surface to be puttied first remove all loose paint, splinters, dirt, chalk, grease, etc. Sand all glossy areas to help insure maximum adhesion. Dust the surface with a clean, dry paint brush. Use only on clean, dry and primed wood surfaces. New or unpainted wood should be fully primed prior to use. Roll putty with hand into shape of a point then press firmly into holes with thumb and forefinger. Holding a clean, dry putty knife in the opposite hand, quickly cut off material in one motion. When properly performed the cut should leave the patched area smooth and filled to capacity - thereby eliminating the need to sand. Large holes and cracks may require more than one application to obtain this result. Once putty has been applied, allow it to form a protective surface skin (top dry). For nail holes and other minor surface defacements this process takes approximately 24 hours. Note: Top drying may be slowed by cold, damp weather plus size and depth of fill. Also, do not touch putty once it has been placed in holes. This action may break the thin surface membrane which has formed. Important: If applying a lacquer top coat, putty should be allowed to dry a minimum of 60 to 80 hours. Again, cold and/or damp weather plus size and depth of fill will increase this waiting period. Once sufficient drying time has elapsed, apply a high quality primer/sealer over all patched areas - inside and out. Areas patched which are going to be top coated with a gloss or semi-gloss paint should also be sealed. The manufacturers liability under any warranty, whether expressed or implied by contract or law, is hereby limited to replacement of this product if found to be defective upon inspection by CPC, Inc. In no case will CPC, Inc. reimburse or be responsible for labor cost or the cost of other consequential damage in conjunction with the use of this product. CPC, Inc. shall not be held liable for any representations or claims made by its employees, agents, dealers or any applicator. Other conditions also apply. Users are responsible to request, understand and agree to these conditions prior to purchase or use of this product.