| |
On surface to be patched first remove all loose paint,
plaster, splinters, dirt, chalk, grease, etc. Check for moisture.
Sand any glossy areas to help insure maximum adhesion. Dust the
surface clean with a dry paint brush. Note: Use only on clean,
dry and primed surfaces. New or unpainted surface should be fully
primed prior to use. Use only in conjunction with high quality
primers, sealers and top coats.
Apply with clean, dry putty or broad knife and press
firmly into areas to be filled. Larger holes and cracks may require
more than one application. Feather out product to help insure
a complete fill. Allow material to thoroughly dry. Drying time
depends on size and depth of fill, environmental conditions and
the substrate on which product is being applied. Do not apply
to outside areas if heavy dew or rain is expected within 24 hours.
If needed, sand lightly until patch is level with surface. Use
of a NIOSH approved dust mask is recommended during the sanding
process. Dust all patched areas after sanding. Apply a high quality
primer/sealer over all patched areas - inside and out. Areas
patched which are going to be top coated with a gloss or semi-gloss
paint should also be sealed.
Sanding and TM-80
TM-80 is an additive manufactured exclusively by
Crawford Products and embodied into every batch of Crawford's
Free.
Because all patching compounds should be sanded to
help eliminate minor surface imperfections in the patch itself,
Crawford's formulated TM-80...the additive that "takes the
work out of sanding." Once dry the patch becomes exceptionally
easy to sand. After sanding simply use a clean, dry paint brush
to remove any residue remaining on the patch. What's left behind
is a smooth, ready-to-prime surface. The patch will eventually
become as hard as a putty coat plaster.
The manufacturer's liability under any warranty,
whether expressed or implied by contract or law, is hereby limited
to replacement of this product if found to be defective upon inspection
by CPC, Inc. In no case will CPC, Inc. reimburse or be responsible
for labor cost or the cost of other consequential damage in conjunction
with the use of this product. CPC, Inc. shall not be held liable
for any representations or claims made by its employees, agents,
dealers or any applicator. Other conditions also apply. Users
are responsible to request, understand and agree to these conditions
prior to purchase or use of this product.
|
Highlights
Directions
