Putty MSDS

Material Safety Data Sheet
Last updated 2008/01/01

Table of contents

I. IDENTIFICATION

PRODUCT NAME: Crawford's Natural Blend Painter's Putty
CHEMICAL NAME, COMMON NAME: N/A
MANUFACTURER'S NAME: Crawford Products Co., INc.
ADDRESS: P.O. Box 4339 Whittier, CA 90607-4339
BUSINESS PHONE: (323) 721-6429
(323) 721-0826 FAX
WEBSITEhttp://crawfords.com

II. PHYSICAL DATA

VAPOR DENSITY (AIR = 1): N/A
SPECIFIC GRAVITY: > 1
SOLUBILITY IN WATER: Insoluble
VAPOR PRESSURE,
mmHg @ 20 degrees C: 		N/A
EVAPORATION RATE
(BUTYL ACETATE = 1): 		N/A
APPEARANCE AND ODOR: Off white thick putty. Mild linseed oil odor.
MELTING POINT OR RANGE, F: N/A
BOILING POINT OR RANGE, F: N/A
HOW TO DETECT THIS SUBSTANCE : This material is a linseed oil (vegetable oil) putty. No known harmful effects or warning properties exist.

III. HAZARDOUS INGREDIENTS

This product contains no known hazardous ingredients. This product is non hazardous according to OSHA Hazard Communication Standard 190.1200

COMPONENT INFORMATION
CAS #
Ground Limestone
471341
Calcium Carbonate*
1317653
White Refined Linseed Oil
(vegetable oil)
8001261
Heat Polymerized Linseed Oil (vegetable oil)
67746081
Organophilic Clay
68953582
Titanium Dioxide
13463677
All other ingredients are < 1%

This product is nonhazardous according to OSHA Hazard Communication Standard 190.1200.

IV. FIRE AND EXPLOSION HAZARD DATA

FLASH POINT, DEGREES F (GIVE METHOD): N/A
AUTOIGNITION TEMPERATURE, DEGREES F: N/A
FLAMMABLE LIMITS IN AIR, VOLUME %: LOWER: N/A
FLAMMABLE LIMITS IN AIR, VOLUME %: UPPER: N/A
FIRE EXTINGUISHING MATERIALS: N/A
SPECIAL FIRE FIGHTING PROCEDURES: NONE
UNUSUAL FIRE AND EXPLOSION HAZARDS: NONE

* Calcium carbonate may contain trace amounts of crystalline silica at levels between 0.01% and 0.5% and varies naturally.

V. HEALTH HAZARD DATA

SYMPTOMS OF OVEREXPOSURE FOR EACH POTENTIAL ROUTE OF EXPOSURE:
INHALED: Contains no volatile components and cannot therefore be inhaled.
CONTACT WITH SKIN OR EYES. No known effect on skin. Eye contact causes irritation.
ABSORBED THROUGH SKIN: No
SWALLOWED: No known symptoms. Call physician. This product does not contain white lead.
HEALTH EFFECTS OR RISKS FROM EXPOSURE.
ACUTE: No known effects.
CHRONIC: No known effects.
FIRST AID: EMERGENCY PROCEDURES
EYE CONTACT: Flush with water holding eyelids open for at least 15 minutes. Call physician .
SKIN CONTACT: No known effects
INHALED: N/A
SWALLOWED: Call physician.
SUSPECTED CANCER AGENT?No. This product's ingredients are not found in the lists below.
Federal OSHA NTP IARC CAL/OSHA (*see note)
*NOTE: California employers using CAL/OSHA regulated carcinogens must register with CAL/OSHA. No none carcinogens are found in this product.
MEDICAL CONDITIONS AGGRAVATED BY EXPOSURE: None known.
RECOMMENDATIONS TO PHYSICIAN: No special procedures required. This product does not contain white lead.

VI. REACTIVITY DATA

STABILITY: Stable
CONDITIONS TO AVOID: N/A
INCOMPATIBILITY (MATERIALS TO AVOID): May react with acid to produce carbon dioxide.
HAZARDOUS DECOMPOSITION PRODUCTS (INCLUDING COMBUSTION PRODUCTS): N/A
HAZARDOUS POLYMERIZATION: Will not occur.

VII. SPILL AND DISPOSAL PROCEDURES

SPILL RESPONSE PROCEDURES (INCLUDE EMPLOYEE PROTECTION MEASURES): Normal clean up. Scoop up. This material will not flow. Avoid any unnecesary contact with eyes
PREPARING WASTES FOR DISPOSAL (CONTAINER TYPES, NEUTRALIZATION, ETC.): Can be stored in any type of container. NOTE: Dispose of in accordance with federal, state and local regulations for non toxic solid waste.

VIII. SPECIAL HANDLING INFORMATION

VENTILATION AND ENGINEERING CONTROLS: No special equipment required.
RESPIRATORY PROTECTION: When sanding, use of a NIOSH approved dust mask is recommneded.
EYE PROTECTION (TYPE): If desired, use standard safety glasses to avoid eye contact.
GLOVES (SPECIFY MATERIAL): If desired, use any rubber or vinyl gloves to avoid skin contact.
OTHER CLOTHING AND EQUIPMENT: No special clothing or equipment required.
WORK PRACTICES, HYGIENIC PRACTICES: Normal hygienic work practice. Do not take internally. Remove from hands and tools and excess material. Wash hands or tools with warm soapy water.
OTHER HANDLING AND STORAGE REQUIREMENTS: Replace water on top of product to prevent in-can drying. Keep containers sealed and airtight. Keep from freezing. (only water on top will have a tendancy to freeze). Putty itself will not freeze.
PROTECTIVE MEASURES DURING MAINTENANCE OF CONTAMINATED EQUIPMENT: No special measures required.

IX. LABELING

LABELING (PRECAUTIONARY STATEMENTS): No precautionary statements are required.
D.O.T. LABEL: Not required.

X. REGULATORY INFORMATION

Superfund Amendment and Reauthorization Act of 1986 (SARA) Title III requires submission of annual reports of release of toxic chemicals that appear in 40 CFR 372 (for SARA 313). This information must be included in all MSDSs that are copied and distributed for this material. Components present in this product at a level which could require reporting under the statute are: NONE

XI. STATE RIGHT TO KNOW:

CALIFORNIA PROPOSITION 65: This product contains no levels of listed substances, which the State of California has found to cause cancer, birth defects or other reproductive harm, which would require a warning under this statute.

MASSACHUSETTS Right-To-Know, Substances List (MSL) Hazardous Substances and Extraordinarily Hazardous Substances on the MSL must be identified when present in products. Components present in this product at a level which could require reporting under the statute are: NONE

Definition: Hazardous Substances ( = > 1%)

PENNSYLVANIA Right-To-Know, Hazardous Substances and Special Hazardous Substances on the list must be identified when present in products. Components present in this product at a level which could require reporting under the statute are: NONE

Definition: Hazardous Substances ( = > 1%)

CALIFORNIA SCAQMD RULE 1113: Does not exceed 250 VOC GPL. Vapor pressure, mmHg at 20 degrees C: N/A

U.S. TSCA LISTING: Ingredients in this product are listed in the U.S. EPA TSCA listing.

HMIS RATING:HEALTH: 0
FLAMMABILITY: 0
REACTIVITY: 0

NOTICE: The information herein is presented in good faith and believed to be accurate as of the effective date shown above. However, no warranty, expressed or implied, is given. Regulatory requirements are subject to change and may differ from one location to another. It is the buyer's responsibility to ensure that its activities comply with numerous federal, state or provincial, and local laws and regulations.

END OF M.S.D.S.